Huizhou Yuanli Industrial Co., Ltd

How to remove the motor for vertical multistage pump

Release time:

2022/07/12

I believe everyone is familiar with vertical multistage pump. This is a multistage pump mainly made of stainless steel, which can be used to pump mildly corrosive media. But after a long time of use, it is inevitable that some failures will occur. If the motor is burned out, etc., and at this time, we need to disassemble it for processing. But some users don't know how to do it. To this end, the following contents have been sorted out for you. Please follow the vertical multistage pump manufacturers to take a look at the following contents.

Wholesale vertical multistage pump Manufacturers china
Precautions for vertical multistage pump: Before operation, it should be powered off, and do not operate with power on, so as to avoid unnecessary safety hazards.
The manufacturer of vertical multistage pump tells you to remove the protective shell (pressed by stainless steel plate) in the middle of the multistage pump bracket, and you can see the coupling inside. The coupling is the rotatable part connecting the motor shaft and the pump shaft. Remove a few hexagon socket screws on the coupling, and the coupling can be divided into two halves and removed, and then remove the screws on the end cover under the motor and the pump bracket, so that the entire motor can be removed.
Well, the above content is provided by the vertical multistage pump manufacturer for everyone, I hope it can be helpful to everyone.